20:00

PDF|

Guide for Cisco-350-601

Quiz Cisco-350-601

Free Test
/ 10

Quiz

1/10
An engineer is implementing OTV on a transport that supports multicast. The solution needs to meet the following requirements: • Establish adjacency to the remote peer by using multicast. • Enable OTV advertisements for VLAN 100 to the other site. Which two commands should be configured to meet these requirements? (Choose two.)
Select the answer
2 correct answers
A.
otv site-vlan 100
B.
otv data-group 232.2.2.0/28
C.
otv use-adjacency-server 172.27.255.94
D.
otv extend-vlan 100
E.
otv control-group 232.1.1.1

Quiz

2/10
An engineer updated firmware on Fabric Interconnects and activates it. However, the endpoint fails to boot from the new firmware image. What is expected to occur in this case?
Select the answer
1 correct answer
A.
The system defaults to the backup image version
B.
The system defaults to and boots into GOLD firmware image
C.
The system defaults to the GOLD firmware image
D.
The system defaults to and boots into kickstart image

Quiz

3/10
Which configuration statically assigns VSAN membership to a virtual Fibre Channel interface?
Select the answer
1 correct answer
A.
switch(config-vsan-cb># vsan 100 bind interface fc 3/1
B.
switch<config-vsan-db)# vsan 100 bind interface vfc 31
C.
switch(config-vsan-db># vsan 100 fc 3/1
D.
switch(config-vsan-db)# vsan 100 interface vfc 31

Quiz

4/10
An engineer must configure OSPF routing on Cisco Nexus 9000 Series Switches. The IP subnet of the Eth 1/2 interface for both switches must be advertised via OSPF. However, these interfaces must not establish OSPF adjacency or send routing updates. The current OSPF adjacency over the interface Eth1/1 on SW1 and Eth1/1 on SW2 must remain unaffected. Which configuration must be applied to both Nexus switches to meet these requirements?
Select the answer
1 correct answer
A.
interface ethernet 1/2 passive-interface default
B.
Interface ethernet 1/2 Ip ospf network point-to-point
C.
interface ethernet 1/2 ip ospf passive-interface
D.
interface ethernet 1/2 no ip ospf passive-Interface

Quiz

5/10
DRAG DROP A network engineer is asked to describe the cloud infrastructure models from the perspective of their operation and access to resources. Drag and drop the descriptions from the left onto the appropriate. Certification Exam Cisco-350-601 Cisco Cisco-350-601 2-1169593948
Select the answer
1 correct answer
Option is correct. Private Cloud: owned, managed, and operated by a single organization. Community Cloud: Owned, managed, and operated by one or more organizations or teams. Public Cloud: Provisioned for open use. Hybrid Cloud: At least two or more separate cloud infrastructures are connected together to facilitate hosted data and application portability.

Quiz

6/10
An engineer needs to perform a backup of user roles and locales from Cisco UCS Manager to replicate the setting to a different fabric interconnect. The engineer wants to review the file before importing it to a target fabric interconnect. Which backup type must be selected to meet these requirements?
Select the answer
1 correct answer
A.
all configuration
B.
system configuration
C.
logical configuration
D.
full state

Quiz

7/10
An engineer must configure HTTPS secure management for Cisco UCS Manager using a key ring named kr2016 and a key size of 1024 bits. The environment consists of a primary fabric interconnect named UCS-A and a secondary fabric interconnect named UCS-B. Which command sequence must be used to accomplish this goal? Certification Exam Cisco-350-601 Cisco Cisco-350-601 4-4176803243
Select the answer
1 correct answer
A.
Option A
B.
Option B
C.
Option C
D.
Option D

Quiz

8/10
Which server policy is used to install new Cisco IMC software on a server?
Select the answer
1 correct answer
A.
host firmware policy
B.
hypervisor firmware policy
C.
BIOS software policy
D.
Cisco IMC software policy

Quiz

9/10
A network engineer must perform a backup and restore of the Cisco Nexus 5000 Series Switch configuration. The backup must be made to an external backup server. The only protocol permitted between the Cisco Nexus switch and the backup server is UDP. The backup must be used when the current working configuration of the switch gets corrupted. Which set of steps must be taken to meet these requirements?
Select the answer
1 correct answer
A.
1 Perform a startup-config backup to an FTP server. 2 Copy startup-config in the boot flash to the running-config file
B.
1 Perform a running-config backup to an SFTP server 2 Copy backup-config from the SFTP server to the running-config file
C.
1 Perform a running-config backup to an SCP server 2 Copy running-config in the boot flash to the running-config file
D.
1 Perform a startup-config backup to a TFTP server 2 Copy backup-config from the backup server to the running-config file

Quiz

10/10
Refer to the exhibit. Certification Exam Cisco-350-601 Cisco Cisco-350-601 7-1803009692 An engineer is configuring a VSAN on the network Which option must be selected to create the VSAN?
Select the answer
1 correct answer
A.
Fabric B
B.
FC Zoning Enabled
C.
Fabric A
D.
Common/Global
Looking for more questions?Buy now

Cisco-350-601 Practice test unlocks all online simulator questions

Thank you for choosing the free version of the Cisco-350-601 practice test! Further deepen your knowledge on Cisco Simulator; by unlocking the full version of our Cisco-350-601 Simulator you will be able to take tests with over 441 constantly updated questions and easily pass your exam. 98% of people pass the exam in the first attempt after preparing with our 441 questions.

BUY NOW

What to expect from our Cisco-350-601 practice tests and how to prepare for any exam?

The Cisco-350-601 Simulator Practice Tests are part of the Cisco Database and are the best way to prepare for any Cisco-350-601 exam. The Cisco-350-601 practice tests consist of 441 questions and are written by experts to help you and prepare you to pass the exam on the first attempt. The Cisco-350-601 database includes questions from previous and other exams, which means you will be able to practice simulating past and future questions. Preparation with Cisco-350-601 Simulator will also give you an idea of the time it will take to complete each section of the Cisco-350-601 practice test . It is important to note that the Cisco-350-601 Simulator does not replace the classic Cisco-350-601 study guides; however, the Simulator provides valuable insights into what to expect and how much work needs to be done to prepare for the Cisco-350-601 exam.

BUY NOW

Cisco-350-601 Practice test therefore represents an excellent tool to prepare for the actual exam together with our Cisco practice test . Our Cisco-350-601 Simulator will help you assess your level of preparation and understand your strengths and weaknesses. Below you can read all the quizzes you will find in our Cisco-350-601 Simulator and how our unique Cisco-350-601 Database made up of real questions:

Info quiz:

  • Quiz name:Cisco-350-601
  • Total number of questions:441
  • Number of questions for the test:50
  • Pass score:80%

You can prepare for the Cisco-350-601 exams with our mobile app. It is very easy to use and even works offline in case of network failure, with all the functions you need to study and practice with our Cisco-350-601 Simulator.

Use our Mobile App, available for both Android and iOS devices, with our Cisco-350-601 Simulator . You can use it anywhere and always remember that our mobile app is free and available on all stores.

Our Mobile App contains all Cisco-350-601 practice tests which consist of 441 questions and also provide study material to pass the final Cisco-350-601 exam with guaranteed success. Our Cisco-350-601 database contain hundreds of questions and Cisco Tests related to Cisco-350-601 Exam. This way you can practice anywhere you want, even offline without the internet.

BUY NOW